With way/431490830 I dropped it to landuse=commercial only, so that the individual buildings inside of it wouldn't overlap.

This area might need a bit of cleanup to match the bing imagery available - its close, but not quite right.

You might be interested to find the 'square' tool, or shortcut key = S in ID; which makes it a lot easy to get neat looking buildings.

I've tweaked this a bit to remove overlaps

Ah hah. Probably shouldn't go from the potentially copyrighted developer maps; but since you've got a block there you've probably surveyed it directly :)

Nice work on the detail around freeling and other areas, welcome to OSM!

I swapped some of these to 'farmland' (more for the paddocks and similar), as opposed to farmyard (the bit nearer the houses, usually with a shed or two that is bigger than a typical backyard)

This one is a bit odd, its not really a reservoir like a farm dam so much as an emergency? drainage area... and if the water was that close to the road/houses, would be a bit of a problem. May better as waterway=drain for the main 'drain' part of it (centre/deepest bit)?

What's the source of this change, it doesn't match Bing, Mapbox or even some non-free aerial imagery very well

Ah nice, we did some work to add names, but not so much work to find the ones that were slightly off from data.sa.gov.au info

Ah nice, hadn't spotted the building mapping in Gawler! Will chip in a few hours to it at some point

Alright, that's reverted now - the blue line through the park was actually an administrative boundary, not quite sure why it looked like a road

This seems to have broken the Largs Bay admin boundary, and turned it into a highway, going to revert in a bit

I've tweaked how way/435898495 is modelled - tracing the individual buildings inside of it.

It can be a little tricky with the ID editor making some assumptions about something being a building, when you are tracing the whole area.

Ah nice work! For the buildings, try the 'S' shortcut key to square them.

Keep up the mapping!

Ah nice, I hadn't noticed the house mapping you added - thanks! We've finally fleshed out around here almost completely.

One thing I've been meaning to do more of is indoor mapping - room=shop (room=*) combined with POI tagging kind of thing - http://openlevelup.net/ shows the results. For places around Rundle Mall, it might be a handy tool

Is it Strickland or Strickleland? Through work we have some (non free) documentation that suggests its not Strickleland.

Ah nice work. You can use the 'S' shortcut to square buildings, which makes them a bit neater/easier to trace. Keep it up

Could have meant http://www.revivebeautyclinic.com.au/ (presumably at the shopping centre up the road); or maybe https://www.facebook.com/maryannesbeautypadstow/ ... but that's in a different spot.

New thing we are trialling here - Car Gladiators. Two drive in, one drives out!

Its weirdly shaped, because they've dug a bit hole where the northmost lane used to be and put the traffic right next to the other lane - previously separated by a wide median.

I've tweaked the two not to intersect anymore; though it will need a bit more attention to remodel the lights - will try to grab imagery on Tuesday.

Good start on the housing in this area. I've used the 'square buildings' tool in ID (shortcut: S) to straighten up a few of these to better match the imagery. Keep it up

node/2597881208 is the existing petrol station/HJ's combination. https://www.hungryjacks.com.au/stores puts only one there.